Mam dokładnie ten sam problem
----- Original Message -----
From: "Tomasz Krawczyk" =
<computers@o2.pl>
To: <slacklist@slackware.com.pl>
Sent: Friday, June 06, 2003 10:25 PM
Subject: [slacklist] komunikaty przy starcie =
slacka
> WItam!
>
> Co powiedzie na te komunikaty przy starcie =
slacka??
>
> Set up the loopback interface
> Set up the eth0 interface
> eth0: Setting half-duplex based on =
auto-negotiated partner ability 0000.
> Set up the eth1 interface
> eth1: Setting half-duplex based on =
auto-negotiated partner ability 0000.
> Set up the gateway interface
> 8139cp: 10/100 PCI Ethernet driver v0.3.0 (Sep =
29, 2002)
> insmod: =
/lib/modues/2.4.20/kernel/drivers/net/8139cp.o.gz: =
No
> such device
> insmod: =
/lib/modues/2.4.20/kernel/drivers/net/8139cp.o.gz: Hint: =
> erors can be caused by incorrect module =
parameters, including invalid IO
or
> IRQ parameters.
> =
You may find more information in syslog or the output =
from
dmesg
> insmod: =
/lib/modues/2.4.20/kernel/drivers/net/8139cp.o.gz: insmod
> =
/lib/modues/2.4.20/kernel/drivers/net/8139cp.o.gz failed
> insmod: =
/lib/modues/2.4.20/kernel/drivers/net/8139cp.o.gz: insmod =
8139cp
> failed
> 8139cp:r10/100 PCI Ethernet driver v0.3.0 (Sep =
29, 2002)
>
> i tak kilka razy ro co powyzej.
>
> Zastanawiam sie co to oznacza i dlaczego on =
usiluje dostac sie do modulu
> 8139cp skoro slack przy instalce wykrywa =
8139too
>
> i druga lamerska kwestia : w jakim pliku =
skonfigurowac masquerade i gdzie
> postawic eth1
>
> z gory dzieki za pomoc
>
> pozdro for all
>
> tomo
>
>
>
>